What should an ESG reporting platform do?
It should turn activity data into a greenhouse gas inventory built to the GHG Protocol, with every emission factor and global warming potential traceable to its source. It should map that one inventory to each rule a company reports under, such as the EU’s ESRS, ISSB-based standards and California’s SB 253. And it should keep an evidence trail an assurer can follow. As of 2 October 2026, no major rule yet requires sustainability data to be XBRL-tagged, so tagging is a roadmap question, not a reason to buy.
Vendors sell ESG reporting platforms on dashboards and framework logos. The rules ask for something narrower and harder: numbers that are complete, consistent between reports and checkable by an auditor. This guide works back from the instruments themselves (the GHG Protocol, ESRS, IFRS S2, ISSA 5000 and the California Air Resources Board’s 2026 reporting guidance) to the questions worth asking before you sign. The same products are also sold as sustainability reporting tools, ESG software or carbon accounting software; the questions apply to all of them, and a section on carbon accounting software sets out which kind suits which company.
What the rules ask of the software
Every major disclosure rule starts from the same thing: a greenhouse gas inventory measured to the GHG Protocol. The differences between rules are in what is reported on top of it, who must report, and how far the numbers are assured. The ESG regulations reference covers who must report where and when. The table below sets out what those rules require of the system that produces the numbers.
| Requirement | Where it comes from | What to check in a platform |
|---|---|---|
| Scope 2 both ways | The GHG Protocol Scope 2 Guidance (2015) requires location-based and market-based figures. ESRS E1 asks for both; IFRS S2 asks for location-based, plus information on contractual instruments | Both methods calculated from the same electricity data, with the contractual instruments (certificates, power purchase agreements) held as records, not typed-in totals |
| Scope 3 by category | The Scope 3 Standard’s 15 categories; ESRS E1 and IFRS S2 both require scope 3, with phase-in reliefs | Category-level results, the method used for each (spend-based, average-data or supplier-specific), and the share of each category from supplier data |
| Stated GWP basis | IFRS S2 uses global warming potentials from the latest IPCC assessment report. Amendments issued on 11 December 2025 add a jurisdictional relief from 1 January 2027 | Each gas converted with named IPCC AR6 (or required) values, and the basis shown in the output, not buried in a factor library |
| Sourced emission factors | Assurance: an assurer must obtain evidence for each number. ESRS, IFRS S2 and SB 253 all lead to assurance | Every emission factor shows its publisher, edition and the row it came from, and a factor update does not silently restate past years |
| One dataset, several reports | The ESRS–ISSB interoperability guidance (EFRAG and IFRS Foundation, May 2024); double materiality under ESRS against financial materiality under ISSB | One inventory feeding each framework’s report, so the same scope 1 figure cannot differ between your CSRD statement and your SB 253 filing |
| Supplier requests within limits | In the EU, from financial years beginning 1 January 2027, a company with up to 1,000 employees can decline requests that go beyond the value chain cap: the essential datapoints of the voluntary standard listed in Annex II of Delegated Regulation (EU) 2026/1560 | Supplier questionnaires that can be limited to the value chain cap’s datapoints in the voluntary standard |
| A plain scope 1 and 2 report | For 2026, CARB accepts SB 253 reports through a voluntary intake platform or by email. It takes an existing annual report, data already reported to another programme, or its draft template | Export of scope 1 and 2 as a standalone document for the 10 November 2026 deadline |
Most of this is GHG accounting, not ESG in the wider sense. Social and governance disclosures (workforce, pay, board oversight) are mostly narrative and come from HR and legal systems. The carbon numbers are where errors are easy to make and hard to defend, and they are what the assurance requirements reach first.
The part that decides assurance: the evidence trail
Limited assurance is now the norm for regulated emissions reporting, and reasonable assurance is on the way:
| Rule | Assurance |
|---|---|
| EU CSRD | Limited |
| California SB 253 | Limited assurance in the statute. CARB will accept 2026 reports without it; reasonable assurance on scope 1 and 2 from 2030 |
| Australia AASB S2 | Phased to reasonable |
| Japan SSBJ | Required from the year after reporting starts |
| Singapore SGX | Scope 1 and 2 from FY2029 |
The global standard for that work is ISSA 5000, the IAASB’s sustainability assurance standard. It applies to periods beginning on or after 15 December 2026. Under it, the assurer needs to get from a reported total back to the activity data, the factor and the calculation that produced it.
A platform makes that possible or impossible. In our view, these are the features that matter most to an assurer:
- Lineage: any reported total can be opened to show its lines, and each line shows its source document, its factor and the arithmetic.
- Change history: who changed what, when and why, including factor updates and restatements.
- Locked periods: a closed reporting year cannot be edited without a recorded restatement.
- Estimates labelled: estimated and supplier-reported figures are tagged as such, so their share can be disclosed.
- Factor versions pinned: the factor edition used in each year is recorded. Re-running last year’s inventory gives last year’s answer, not one changed by this year’s factor release.
The last point catches teams out most often. Factor publishers revise their datasets, and many platforms refresh their libraries automatically. If a refresh rewrites prior years without a record, the base year moves and the assurer cannot reproduce the published figure. If you build in-house, the GreenCalculus API returns each factor with its source and lets you pin a dataset version for this reason.
Digital tagging: not yet required
Several vendors sell XBRL tagging as a compliance must-have. As of 2 October 2026, it is not one:
- EU: the CSRD requires sustainability statements to be marked up in the European Single Electronic Format, but Directive (EU) 2026/470 says companies should not be required to do so until the rules for marking up are adopted in a delegated regulation. EFRAG published a draft XBRL taxonomy for the revised ESRS on 17 September 2026, with consultation open until 11 November 2026 and final advice to ESMA and the Commission expected by the end of 2026.
- ISSB: the IFRS Sustainability Disclosure Taxonomy (published April 2024) lets jurisdictions require tagging but adds no requirement of its own. An update for the December 2025 amendments to IFRS S2 closed for comment on 28 September 2026.
- California: CARB’s 2026 intake takes uploaded reports, not tagged data.
A platform that can tag later is useful. Paying for tagging in 2026 is paying ahead of the rule.
Eight questions to ask a vendor
- Show me where one number comes from. Pick a scope 2 total in the demo and ask to see the meter or invoice lines, the factor, its publisher and edition, and the arithmetic.
- What happens to last year when you update a factor? The answer you want is “nothing, unless you record a restatement.”
- Which IPCC report are your GWPs from, and can we choose? IFRS S2 expects the latest report unless a jurisdiction says otherwise.
- Do you calculate scope 2 both ways from the same data? Both methods should come from the same records, not be entered as two numbers.
- How is each scope 3 category calculated, and how much is spend-based? Spend-based estimates are acceptable to start with, but they should be labelled and replaced over time.
- Can one inventory produce our ESRS, ISSB-based and SB 253 outputs without re-entering data?
- Has an assurance provider reviewed a client’s inventory in your platform? Ask which standard the engagement used: ISSA 5000, ISAE 3000 or ISAE 3410.
- Can we export everything (raw data, factors and calculations) in an open format if we leave?
Carbon accounting software: which kind you need
Carbon accounting software is the calculation core of everything above: it turns fuel, electricity, travel and purchasing records into a greenhouse gas inventory. Products sold under that name range from free workbooks to enterprise platforms, and they work in different ways. Knowing which kind you are looking at matters more than any feature list.
| Kind | How it works | Suits | Watch for |
|---|---|---|---|
| Free calculators and workbooks | You enter a year of activity data and the tool applies published factors. The EPA’s Simplified GHG Emissions Calculator is a free Excel tool covering scopes 1, 2 and 3; the GHG Protocol publishes free calculation tools for sources such as stationary combustion and transport | A first inventory for a company with a few sites. The EPA says its calculator is meant mainly for small and medium-sized organizations early in GHG management | One year at a time, and you keep the evidence trail yourself |
| Spend-based platforms | Connect to accounting data and multiply what you spend in each category by a spend-based emission factor (kg CO2e per dollar) | A quick first estimate of scope 3 purchases across many suppliers | Spend factors follow prices, not physical quantities, so a price rise reads as more emissions. Label the results as estimates and replace the largest categories with activity or supplier data over time |
| Activity-based platforms | Collect meter readings, fuel and travel records and supplier data across sites, and apply a factor library to each line | Companies with several sites, scope 3 supplier programmes or assurance on the way | Whether every factor is traceable and version-pinned (see the eight questions) |
| ESG and disclosure suites | An inventory plus the other disclosures, formatted for ESRS, IFRS S1 and S2 or SB 253 | Companies reporting under one or more of those rules | The same as above: the emissions numbers are what assurance reaches first |
| Product footprint and LCA tools | Model the emissions of a single product across its life cycle, for product footprints and environmental product declarations | Manufacturers and construction product makers asked for product-level figures | These answer a different question from a company inventory; most companies need one, some need both. Our LCA software comparison covers the main tools |
Two special cases. Banks and investors measure the emissions of their loans and investments (scope 3 category 15) under the PCAF Standard, so check that a platform supports it before assuming a general tool will. And if you build your own calculations, the GreenCalculus API returns emission factors with their source and edition, so the evidence trail comes with the number.
For a small business, start with the EPA calculator or a sourced spreadsheet before paying for software. If customers or a bank are asking for data, the EU’s voluntary standard for SMEs sets out the datapoints they can reasonably request.
Platform or spreadsheet?
The rules do not require software. CARB’s first-year guidance accepts an existing report, and a well-kept workbook with sourced factors can produce a defensible scope 1 and 2 inventory for a company with a few sites. In our view, a platform starts to pay for itself when one of these is true:
- you report scope 3 from supplier data across many suppliers;
- you report under more than one framework and the numbers must agree;
- you face limited or reasonable assurance, and the assurer needs lineage that a spreadsheet keeps only by discipline;
- many people across many sites enter data, and you need controls on who changes what.
Whichever route you take, the inventory is only as good as its emission factors. A platform with an untraceable factor library is harder to defend than a spreadsheet that cites its sources.
Finding a provider
The GreenCalculus directory lists providers by what they do: regulatory reporting, carbon software and assurance and verification. Each listing names the standards the provider works to. Listings are paid, and labelled as such. Use the eight questions above with whichever vendors you shortlist. If you are not yet sure which framework applies to you, the sustainability reporting framework finder narrows it down first.
Frequently asked questions
No. No rule requires software. For 2026, California’s Air Resources Board accepts SB 253 scope 1 and 2 reports as an existing annual report, data already reported to another programme, or its own draft template. A platform becomes worthwhile when you report scope 3 from supplier data, report under several frameworks, or face assurance that needs a clear evidence trail.
Not yet. As of 2 October 2026, Directive (EU) 2026/470 suspends the EU requirement to mark up sustainability statements until a delegated regulation sets the rules. EFRAG’s draft taxonomy for the revised ESRS is out for consultation until 11 November 2026. The ISSB taxonomy adds no requirement of its own. The ability to tag later is useful, but it is not a 2026 compliance need.
An assurer must be able to trace each reported total back to its activity data, the emission factor used and the calculation. That needs four things: factors with a named source and edition; a change history; locked reporting periods; and estimates labelled as estimates. ISSA 5000, the IAASB’s sustainability assurance standard, applies to periods beginning on or after 15 December 2026.
Carbon accounting software calculates a greenhouse gas inventory. An ESG reporting platform usually adds the other disclosures (social, governance, policies and targets) and formats the result for frameworks such as ESRS or IFRS S1 and S2. Many products do both. The emissions calculation is the part that disclosure rules and assurance scrutinise most closely.
Usually another name for an ESG reporting platform: software that collects sustainability data, calculates a greenhouse gas inventory and produces disclosures for frameworks such as ESRS, IFRS S1 and S2 or California’s SB 253. The term is also used for narrower tools, such as framework finders, templates and single-standard calculators. Judge any of them by whether its numbers trace back to sourced emission factors and an evidence trail.
Yes. The US EPA’s Simplified GHG Emissions Calculator is a free Excel tool that calculates scopes 1, 2 and 3 from a year of activity data, intended mainly for small and medium-sized organizations. The GHG Protocol also publishes free calculation tools for common sources such as stationary combustion and transport. Paid platforms add multi-site data collection, supplier programmes and the controls that assurance needs.
The one whose numbers you can defend. A free calculator can suit a company with a few sites; a spend-based platform gives a quick first scope 3 estimate; a company facing assurance needs a platform where every total traces back to its activity data and a sourced, version-pinned emission factor. Ask any vendor to show you where one number comes from before you compare features.
Software that collects a company’s environmental, social and governance data, calculates its greenhouse gas emissions and produces the reports that rules such as the EU’s CSRD, ISSB-based standards and California’s SB 253 require. A good one keeps one inventory for every framework. It traces every emission factor to its source and keeps an evidence trail an assurer can follow.